3/25/2023 0 Comments Steam thermodynamics calculatorIn case of wet steam, the actual enthalpy can be calculated with the vapor quality, x, and the specific enthalpies of saturated liquid water and dry steam: The specific enthalpy of saturated liquid water (x=0) and dry steam (x=1) can be picked from steam tables. To produce of 1 kg of saturated steam from feedwater, about 1789/206 x 1 kg = 8.68 kg of primary coolant is required. Since the difference in specific enthalpies is less for primary coolant than for feedwater, it is obvious that the amount of primary coolant will be higher than 1kg. Feedwater is then evaporated and the pressurized steam ( saturated steam 280☌ 536☏ 6,5 MPa) leaves the steam generator through steam outlet and continues to the steam turbine. The feedwater (secondary circuit) is heated from ~230☌ 446☏ to the boiling point of that fluid (280☌ 536☏ 6,5MPa). The feedwater ( water 230☌ 446☏ 6,5MPa) is pumped into the steam generator through the feedwater inlet. The primary coolant leaves (water 295☌ 563☏ 16MPa) the steam generator through primary outlet. The hot primary coolant ( water 330☌ 626☏ 16MPa) is pumped into the steam generator through primary inlet. Assume that there are no energy losses, this is only idealized example. The fact that the absolute value of specific enthalpy is unknown is not a problem, however, because it is the change in specific enthalpy (∆h) and not the absolute value that is important in practical problems.Ĭalculate the amount of primary coolant, which is required to evaporate 1 kg of feedwater in a typical steam generator. For example, the specific enthalpy of water or steam is given using the reference that the specific enthalpy of water is zero at 0.01☌ and normal atmospheric pressure, where h L = 0.00 kJ/kg. Normally, the enthalpy of a substance is given with respect to some reference value. In general, enthalpy is a property of a substance, like pressure, temperature, and volume, but it cannot be measured directly. The specific enthalpy is equal to the specific internal energy of the system plus the product of pressure and specific volume. Note that the enthalpy is the thermodynamic quantity equivalent to the total heat content of a system. It equals to the total enthalpy (H) divided by the total mass (m). The specific enthalpy (h) of a substance is its enthalpy per unit mass. Engineers use the specific enthalpy in thermodynamic analysis more than the enthalpy itself. The enthalpy can be made into an intensive, or specific, variable by dividing by the mass. Enthalpy in Intensive Units – Specific Enthalpy Extensive and intensive properties of medium in the pressurizer.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |